INTERSTATE COMPLIANCE CHECK

NHWI

This 1,123 mile haul crosses state lines, triggering Federal FMCSA jurisdiction.

TOTAL MILEAGE
1,123 miles
EST. DRIVE TIME
19 Hours
(@60mph avg)
REQ. RESET BREAKS
1
(10-hour resets per FMCSA 395.3)

MANDATORY FILINGS

Enforcement Warning: Operating without these filings in Wisconsin can result in immediate Out-of-Service (OOS) orders and fines starting at $1,100 (Violation 392.2).

The Route: New Hampshire to Wisconsin

This route guide outlines a common and efficient path for commercial truck drivers traveling from New Hampshire to Wisconsin. Please note that specific origins and destinations within each state may necessitate slight variations. Always consult your dispatch and utilize up-to-date GPS navigation before and during your trip.

The primary Interstate Highways utilized are:

  • I-89 South/West (New Hampshire to Vermont): Begin your journey on I-89 heading southwest towards Vermont.
  • I-91 South (Vermont to Massachusetts): Continue south on I-91 after entering Vermont.
  • I-90 West (Massachusetts Turnpike, tolls apply): Merge onto I-90 West in Massachusetts, a toll road also known as the Mass Pike. Expect toll plazas.
  • I-90 West (New York State Thruway, tolls apply): Continue west on I-90 as it enters New York. This portion of I-90 is also a toll road.
  • I-90 West (Pennsylvania): As you continue West, I-90 will cross into Pennsylvania.
  • I-90 West (Ohio): Continuing, I-90 West will cross into the State of Ohio.
  • I-90 West (Indiana): I-90 then goes through Indiana.
  • I-90 West (Illinois): Finally, I-90 goes through Illinois.
  • I-90 West (Wisconsin): I-90 will take you the final distance into Wisconsin. Specific exits from I-90 will vary depending on your final destination.

Compliance & Permits

Navigating the regulations across multiple states requires diligent attention. Be sure your truck and load are compliant with all relevant state and federal regulations.

Weigh Stations and Ports of Entry:

Expect to encounter the following weigh stations along this route. This is not an exhaustive list, and locations can be temporarily closed. Pay attention to signage and electronic notifications.

  • Vermont: Typically, weigh stations are open along I-91 near the MA border.
  • Massachusetts: Often, a weigh station near the NY border on I-90
  • New York: New York has numerous weigh stations along I-90
  • Pennsylvania: Pennsylvania often has weigh stations along I-90
  • Ohio: Ohio has frequent weigh stations and inspections on I-90
  • Indiana: Inspect Indiana's DOT website for current weigh station status.
  • Illinois: Port of Entry weigh stations are typically open just West of Indiana on I-90
  • Wisconsin: Wisconsin ports of entry are often present on I-90 near the border with Illinois.

Permits:

  • New York Highway Use Tax (NY HUT): If your vehicle's gross weight exceeds 18,000 pounds, you are likely required to have a NY HUT permit to operate in New York. Ensure you are compliant with reporting requirements.
  • Illinois IRP (International Registration Plan): Proper IRP registration is crucial for multi-state operations and ensuring you are paying appropriate registration fees for your fleet based on miles.

Risks & Hazards

Be prepared for various seasonal weather risks that can impact this route.

  • Winter (November - March): Heavy snow and ice are common threats across all states along the route, particularly in upstate New York, Pennsylvania, and Wisconsin. Reduced visibility, slippery road conditions, and potential road closures are possible. Monitor weather forecasts closely and adjust your driving accordingly. Carry chains and winter survival gear.
  • Summer (June - August): High temperatures can pose a risk of tire blowouts and engine overheating. Ensure your vehicle is properly maintained and check tire pressure regularly. Schedule rest stops to avoid driver fatigue.

NEW AUTHORITY?

If this is your first time crossing state lines, you need a new MC Number (Operating Authority).

Get BMC-91X Filing →